So friday I got the brake parts to finish my build, I figured that it might be nice to be able to stop. So today I figured out how not to get the brake puck
out to replace the o-ring. I was using the air hose and at first it was not working so I shoved the puck back in and tried it again, this time the fing puck
comes flying out and smashes the shit out of my finger between the the puck and the other side of the brake, man did that hurt, cut up my finger real good. So
after icing the finger for 30 minutes I finally got the brake on and take it for a spin. the brake mounts for the Cerani forks were drilled slightly off so
the top of the brake roter was rubbing against the brake so off come the brakes again and out with the drill. Finally got that fixed and took it for a spin
around the hood. Guess I did not get the big nut on the oil tank tight cuz I stopped at the light looked down and saw a big puddle of oil. So back to the
house I go but I can't get a fing cresent wrench on the nut cus of the fender and swing arm and I don't have an end wrench big enough. argh!!!
Can't remember if the washer was on there or not so I had to take it off to check, So I finally get it back on and cranked down but then I had to go take
care of the kids. So I will try it again tomarrow.
Getting close
Getting close

