Oh yeah, bearings. Did you just chuck the entire hub into a lathe? I've got a good lathe (a couple actually). Sounds like I'm gonna need some parts from ya.

Hey, if I'm gonna run a different caliper do you know of any small calipers that float? Something I could mount solid to the swingarm instead of doing that whole bracket-from-the-axle thing.

Can I get a few prices from ya:

Stainless Spokes for 19" to front hub
Stainless Spokes for 17" to front hub (or are the 750A rears 18?)
Front wheel bearings
Rear wheel bearings
Tapered bearings and races for the neck (What is the O.D. of the races? I'm trying to put a CB750 frontend on a 350 twin)

Also, while I'm askin, can you get CB350 twin stuff? I need a topend gasket set and a pair of overbore pistons.

And, for the other project (at Jeromy's) I'm gonna need some good 1" controls (throttle, brake master, clutch). What do you recommend that isn't too pricey (not like Ness or PM or something). Brake master needs to be for dual-caliper (if it matters). It's CB750SS dual calipers. Thanks man.