so i took my rear wheel off, and the dampers the (8 big rubber pieces) are original, dry rotted, and allow for a lot of play. any ideas where to get new ones.
other than the dealer. the bearings are a little iffy too...thanks, josh
 |
Hondachopper.com's
Community Board is sponsored by its dedicated members and the G.O.T.F. THANK YOU! |
 |
rear wheel damper
| Author | Comment | ||
|---|---|---|---|
 76josh |
rear wheel damper |
Lead | |
|
Posts: 30 (06/19/08 11:32 AM) |
|
||
|
constriktor |
|||
|
Posts: 531 (06/19/08 12:10 PM) |
"It'll destroy you if you try to make it mean anything to anyone but yourself." - Henry Rollins
|
||
|
76josh |
|||
|
Posts: 31 (06/21/08 9:08 AM) |
thanks constriktor...the part number is a little confusing. when you ordered it, did you order quantity of 4 and get 8 pieces or what? in the diagram it shows 3 part numbers, but there are only 2 different pieces. im confused........ |
||
|
constriktor |
|||
|
Posts: 535 (06/21/08 10:31 AM) |
i ordered four; each set of two is connected with a little rubber tab that hangs over the walls inside the hub that separate the cush drive into quadrants.
the diagram for the '78 only shows one part number. i've found that for a part on the diagram, the table below will show a couple honda part numbers that have been superceded by a new one. maybe that's what you're seeing. n
"It'll destroy you if you try to make it mean anything to anyone but yourself." - Henry Rollins
|
||
|
76josh |
|||
|
Posts: 32 (06/21/08 2:02 PM) |
awesome thanks alot!
|
||
